Cannot Read the Model List Correctly in Claude Code
Quick fix
This issue concerns an older configuration that changed with cc-switch 4.0. If it still occurs after upgrading, report the version and reproduction steps.
Symptom
Section titled “Symptom”在claude code中,不能正确读取模型列表,In Claude Code, the model list cannot be read correctly.
The reporter used cc-switch 3.17.0 to configure a local network Qwen model, but Claude Code still displayed deepseek-chat. Manually switching models and restarting did not help. The maintainer explained that the interface and configuration writing behavior changed significantly in cc-switch 4.0, so the issue was closed. The issue did not confirm a specific cause or verify a configuration fix.
The maintainer suggested trying cc-switch 4.0. If the problem persists after upgrading, report it again with the version and reproduction steps.
Affected Versions
Section titled “Affected Versions”Source Issues
Section titled “Source Issues”This page is distilled from 1 real issues
- Has anyone successfully used cc-switch to configure Claude Code to connect to a local network Qwen model?
- This issue does not provide successful configuration steps. The maintainer suggested trying cc-switch 4.0; if the problem persists, report it again with the version and reproduction steps.
Related problems
Section titled “Related problems”This is an unofficial community wiki with no affiliation to the cc-switch authors or the project itself. Its content is compiled from the project's public GitHub issues. This site distributes no software.